43XG Assembly Instructions
- To assemble the antenna, join the two
sections of the boom using the joining brackets bolts and
wing nuts. Ensure that the holes that locate the directors
are on the top of the boom.
 Place
the black balun box on the underside of the boom and fix
with thumb screw bolt provided.
- Attach the tilt bracket assembly to the
rear of the boom and tighten the wing nuts in the desired
position. (Note this assembly can be fitted to enable either
a vertical or horizontal installation, depending on your
local area.)
- To fit the directors to the boom, line
up each piece with a corresponding hole in the boom and
press firmly to snap together Ensure that each director
is fitted with the arrow pointing towards the front. As
each director assembly is identical, it does not matter
in which order they are fitted.
- After the directors have been fitted,
attach the two large corner reflector screens to the boom
by sliding the metal brackets under the head of the screw
and the wing nut.
- Fix antenna to mast and firmly tighten
all screws.
Note, illustration shows an installation
for a horizontally antenna. By changing the orientation of the
tilt assembly, a vertically mounted installation can be achieved. |
